Stepper Motor Controller Card v1.2 One of these boards controls each stepper motor in the RepRap. You'll need three of these to build the Darwin design. Prerequisites ...

-- Main.ForrestHiggs 26 Jan 2006 FAQ Index Calibration Controllers Building the JDM Programmer board for the PIC16F628 chip Coordinate Systems Design Rules Extruder ...

Generation 1 Electronics Once you start putting electricity into your RepRap even at just 12 volts you have to take basic, common sense precautions to avoid fires ...

Generation 1 Firmware Building the RepRap PIC firmware under Linux This page gives instructions on how to compile all the PIC firmware on a Linux system. Programming ...

Programming a PIC The RepRap project uses PIC microcontrollers as the processors for each control board. These need to be loaded up with the appropriate firmware ...

Universal Controller Board v1.2 Overview RepRap uses the same printed circuit design for both the stepper controllers and the extruder controllers, but different ...