RUG/Pennsylvania/State College/Printers/PSU Unit Purple
Revision as of 13:20, 28 April 2013 by DM0lition21 (talk | contribs)
This page is for information about the PSU Unit Purple, which is assembled and undergoing testing. This unit will follow the design of the Ohm. All of the printable parts are printed in PLA and assembled. The purple printer was constructed by Matt R, Deanna M, Bill F, and Yaqi Y.
Operating Specifications
Operating Specifications | |||||||
---|---|---|---|---|---|---|---|
Name | Status | Design | Electronics | Firmware | Extruder | Temperature | Comments |
Purple | Under construction | Ohm | Ramps V1.4 | Marlin | Joe/Kevin/Wade/Greg extruder | ??? | Assembled. The extruder body and hot plate/hot tip are not lined up perfectly, preventing PLA feeding into the extruder. |
Pictures
Builders
Build Team |
---|
Bill Fabrizi |
Deanna Moschitta |
Matt Rockar |
YaqiYang |
|