JBFromOZ

I found out about reprap in August 2012, within a month I had a range of parts coming to me to commence my first prusa mendel build.

I found a Fabster3D Ramps LCD and PCB heater on ebay, ordered that and within a few days that was at my door! I also received a set of opto endstops with that first shipment.

I bought an ABS prusa mendel kit from dcolj, the parts were good quality, came with LM8UU's and also arrived quickly.

a set of smooth rods, and a bunch of stainless M8 rods and nuts and bolts, and a hobbed bolt later and I had the start of my build.

i paid too much for my steppers, but also got a T2.5 belt and pulley set, and an acrylic Y bed.

I have just achieved my first prints from my i3 single plate build, and decided to use the following configuration:

GT2 belts and pulleys,

MGS nema17 extruder

0.9 degree steppers on X and Y axis

M10 stainless threaded rods for Y carriage assembly.

Ramps 1.4 with 4988 gadgets3D pololus

PCB mk2 heat bed

I also ended up with a wiring kit from reprapdiscount, and a fan extender (highly recommended)