ReplicatorG-Skeinforge-RAMPS
Revision as of 14:59, 30 March 2011 by Sebastien Bailard (talk | contribs)
I built a RepRap Mendel with Wade's Geared Extruder.
Here will be the place with the tweaks I did to get it going with ReplicatorG.
Firmware used: Teacup
First of all:
Be sure baudrates match:
Config in replicatorg/machines/ directory comes here:
Modifs made to config.h.ramps (not complete yet)
StepX 1/16 StepY 1/16 StepZ 1/16 StepE 1/4
Turned on XON/OFF protocol, seems to work better.
(more to be added)
Skeinforge settings:
Activate dimension Set to Relative
ReplicatorG settings:
Prferences: Generate separate Z steps (not sure this necessary)