File list
This special page shows all uploaded files.
Date | Name | Thumbnail | Size | Description | Versions |
---|---|---|---|---|---|
06:39, 22 May 2011 | 2 holes in a bolt.png (file) | 721 KB | Wade extruder bolt, filed and hobbed at 2 locations, as provided in my TechZone Huxley kit. | 1 | |
07:42, 22 May 2011 | Extruder gear not round turning.avi (file) | 2.33 MB | Test run of my extruder gear prior fixing. Note on the right the outer circle of the gear moving up and down while it turns. | 1 | |
07:01, 22 May 2011 | Lasercut gear non centered hex hole.png (file) | 1.12 MB | The big extruder lasercut gear as provided by Techzone in their Huxley kit. Note the little "washer" with an hex hole was glued a bit aside regarding the gear round center hole. | 1 | |
08:42, 22 May 2011 | Lasercut huxley gear reassembled.png (file) | 1.21 MB | Here's the result of re-centering the washer on the gear. Used some little wood screws to replace the nail as I had nothing so tiny to hammer in. | 1 | |
07:29, 22 May 2011 | Mounting extruder gear with extra washers.png (file) | 1.15 MB | Added some washers between the gear and the support so that the filament path is aligned with the filed and hobbed hole on the bolt. | 1 | |
10:28, 9 March 2017 | No image available.png (file) | 5 KB | Reverted to version as of 14:19, 30 May 2013 | 12 | |
08:29, 22 May 2011 | Washer separated from gear.png (file) | 694 KB | After 10 minutes of solvent and knife actions, taddaa ! Nearly clean separation of the 2 pieces forming the big lasercut gear of my Techzone Huxley extruder. Although a bit of sanding might be enough, to be sure to work on plane surfaces, I'll do the plac | 1 |