To All, I'm still trying to finish up my printer and I remembered that I have some parts that were never shown as part of any diagram for assembly I could find. Unfortunately, I bought my printer from Botmill, so there's no more help I can get from those lying S.O.B.'s. Accordingly, I was wondering if anyone could identify these "extra" parts for me, since I can't seem to figure out what they are intended for. Here's the pic. [attachment 8066 UnknownParts.JPG] I've attached a picture of all the parts. Any help (or links to how they should be assembled) would be greatly appreciated. Thank you once again, Reprappers. Regards, Mr. Black https://reprap.org/forum/read.php?1,137371,137371#msg-137371 Sun, 09 Aug 2026 04:02:12 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,137371,137483#msg-137483 https://reprap.org/forum/read.php?1,137371,137483#msg-137483 bed-height-spacer-31mm in a drawer somewhere. ^_^]]> Nudel General Tue, 12 Jun 2012 15:41:40 -0400 https://reprap.org/forum/read.php?1,137371,137456#msg-137456 https://reprap.org/forum/read.php?1,137371,137456#msg-137456 C. Cecil General Tue, 12 Jun 2012 12:43:22 -0400 https://reprap.org/forum/read.php?1,137371,137394#msg-137394 https://reprap.org/forum/read.php?1,137371,137394#msg-137394
Since the machine is just a Sells Mendel the original instructions in the Reprap wiki should cover all the mechanical build.]]> nophead General Tue, 12 Jun 2012 03:19:24 -0400 https://reprap.org/forum/read.php?1,137371,137384#msg-137384 https://reprap.org/forum/read.php?1,137371,137384#msg-137384
The piece n the left allows you to adjust to the width of the belt. The width it cuts to is fixed though. Assemble, feed the belt in, pierce Stanley blade through the thin slot so it cuts the belt, then pull the belt through against the blade. Careful though as the belts have a metal insert which will not be cut by the blade.

The 4th item I don't know.]]> CraigRK General Tue, 12 Jun 2012 01:39:19 -0400 https://reprap.org/forum/read.php?1,137371,137373#msg-137373 https://reprap.org/forum/read.php?1,137371,137373#msg-137373 dissidence General Mon, 11 Jun 2012 22:33:22 -0400 https://reprap.org/forum/read.php?1,137371,137371#msg-137371 https://reprap.org/forum/read.php?1,137371,137371#msg-137371
I'm still trying to finish up my printer and I remembered that I have some parts that were never shown as part of any diagram for assembly I could find. Unfortunately, I bought my printer from Botmill, so there's no more help I can get from those lying S.O.B.'s.

Accordingly, I was wondering if anyone could identify these "extra" parts for me, since I can't seem to figure out what they are intended for.

Here's the pic.
[attachment 8066 UnknownParts.JPG]

I've attached a picture of all the parts. Any help (or links to how they should be assembled) would be greatly appreciated.

Thank you once again, Reprappers.

Regards,
Mr. Black]]> MrBlack General Mon, 11 Jun 2012 22:12:26 -0400