Hi, I have just setup my reprappro Huxley and are currently experiencing some print troubleshooting. I have attached an image in this thread. The large one is he austere bunny from thingiverse and the square wall is the .5mm wall from the calibration instructions. I find that as he printer prints a few layers, it starts to offset itself thus printing slipped layers. I found that with the wall print, when there was no infill, it printed fine and didn't slip. I am using the last eat slic3r plugin. I heard a few speculations around loose y axis belts? What do you guys think? Thanks! Rui https://reprap.org/forum/read.php?1,186370,186370#msg-186370 Sun, 14 Jun 2026 13:12:46 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,186370,186404#msg-186404 https://reprap.org/forum/read.php?1,186370,186404#msg-186404
Could also be binding, loose belts, too high acceleration, overheating stepper drivers or motors.]]> Nudel General Thu, 21 Feb 2013 03:50:56 -0500 https://reprap.org/forum/read.php?1,186370,186394#msg-186394 https://reprap.org/forum/read.php?1,186370,186394#msg-186394
have you tried reducing flow rate]]> jamesdanielv General Thu, 21 Feb 2013 03:01:18 -0500 https://reprap.org/forum/read.php?1,186370,186370#msg-186370 https://reprap.org/forum/read.php?1,186370,186370#msg-186370

I have just setup my reprappro Huxley and are currently experiencing some print troubleshooting. I have attached an image in this thread.

The large one is he austere bunny from thingiverse and the square wall is the .5mm wall from the calibration instructions.

I find that as he printer prints a few layers, it starts to offset itself thus printing slipped layers.
I found that with the wall print, when there was no infill, it printed fine and didn't slip.

I am using the last eat slic3r plugin. I heard a few speculations around loose y axis belts?

What do you guys think?


Thanks!
Rui]]> Rui.in.Roskill General Thu, 21 Feb 2013 00:03:43 -0500