Hi im tryin to use SD ramps, iv enabled it in marlin. the software pronterface can pick up the sd card and read the file. when i click on the file it loads the file and starts printing. however when i press the disconnect or pull out the cable from the pc it stops printing. the led is on on the arduino when i plug out the usb and the D1 and D2 is installed on the ramps. Does anyone know where im going wrong. Im naming the files test.gco this is ok isnt it? thanks https://reprap.org/forum/read.php?1,188621,188621#msg-188621 Sun, 09 Aug 2026 01:03:55 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,188621,188739#msg-188739 https://reprap.org/forum/read.php?1,188621,188739#msg-188739 Enlightx General Fri, 01 Mar 2013 13:35:06 -0500 https://reprap.org/forum/read.php?1,188621,188702#msg-188702 https://reprap.org/forum/read.php?1,188621,188702#msg-188702 xclusive585 General Fri, 01 Mar 2013 10:47:02 -0500 https://reprap.org/forum/read.php?1,188621,188658#msg-188658 https://reprap.org/forum/read.php?1,188621,188658#msg-188658 this link, which discusses a conflict issue with the Y-endstop and SD operation, which then outlines a solution, although for printrboard, not the ramps.

In any case, maybe (or not) it relates. if not, sorry for the thread spam. Good luck.]]> xiando General Fri, 01 Mar 2013 08:33:04 -0500 https://reprap.org/forum/read.php?1,188621,188621#msg-188621 https://reprap.org/forum/read.php?1,188621,188621#msg-188621
Does anyone know where im going wrong.
Im naming the files test.gco this is ok isnt it?
thanks]]> fredted1234 General Fri, 01 Mar 2013 06:49:23 -0500