Hello! Can all the plastic pieces of the carthesian be produced with only one printhead with polymorph or is it necessary to use a filler material, i.e. two heads? I'm thinking especially of the swiss-cheese corner pieces... https://reprap.org/forum/read.php?1,1901,1901#msg-1901 Wed, 16 Sep 2026 21:12:56 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,1901,1927#msg-1927 https://reprap.org/forum/read.php?1,1901,1927#msg-1927 blog.reprap.org]]]> nophead General Fri, 18 May 2007 12:22:25 -0400 https://reprap.org/forum/read.php?1,1901,1926#msg-1926 https://reprap.org/forum/read.php?1,1901,1926#msg-1926
So it is possible to make hollow shapes as long as the angle is not to steep (i.e 45 degrees)?]]> mimarob General Fri, 18 May 2007 12:16:01 -0400 https://reprap.org/forum/read.php?1,1901,1902#msg-1902 https://reprap.org/forum/read.php?1,1901,1902#msg-1902 nophead General Thu, 17 May 2007 09:02:50 -0400 https://reprap.org/forum/read.php?1,1901,1901#msg-1901 https://reprap.org/forum/read.php?1,1901,1901#msg-1901
Can all the plastic pieces of the carthesian be produced with only one printhead with polymorph or is it necessary to use a filler material, i.e. two heads?

I'm thinking especially of the swiss-cheese corner pieces...]]> mimarob General Thu, 17 May 2007 05:16:16 -0400