ugh Heater issue again SO after finally getting a print my heater has died , i had it set to heatup to 180c for pla and i noticed it was smoking , which stopped so i continued to slice and print my model, it started and was fine until layer 6ish where the psu shutoff and the print aswell. i started everything back up and tried to reprint but the heater seems to be dead. on the GEN6 board the led for heater is on and there are 12v going to the resistor but it doesnt heat up :# any ideas why ? https://reprap.org/forum/read.php?1,199585,199585#msg-199585 Wed, 22 Jul 2026 00:07:29 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,199585,239370#msg-239370 Re: ugh Heater issue again https://reprap.org/forum/read.php?1,199585,239370#msg-239370 jamesdanielv General Sat, 24 Aug 2013 22:18:01 -0400 https://reprap.org/forum/read.php?1,199585,239056#msg-239056 Re: ugh Heater issue again https://reprap.org/forum/read.php?1,199585,239056#msg-239056
Were you able to fix this on your board, Rooski?]]> stabbs General Fri, 23 Aug 2013 22:17:03 -0400 https://reprap.org/forum/read.php?1,199585,199987#msg-199987 Re: ugh Heater issue again https://reprap.org/forum/read.php?1,199585,199987#msg-199987
tried it and it did heat up to 180c but it took about 45 minutes and couldnt hold the temp while printing :(]]> Rooski General Mon, 15 Apr 2013 13:03:36 -0400 https://reprap.org/forum/read.php?1,199585,199813#msg-199813 Re: ugh Heater issue again https://reprap.org/forum/read.php?1,199585,199813#msg-199813 waitaki General Sun, 14 Apr 2013 21:32:54 -0400 https://reprap.org/forum/read.php?1,199585,199754#msg-199754 Re: ugh Heater issue again https://reprap.org/forum/read.php?1,199585,199754#msg-199754 if so what would i have to change if anything ?



its 10ohm 10watts , i figure i could secure it to the side of the block with thermal paste and alot of kapton until i can order a new resistor. just wondering if itll be able to reach temp needed :\
]]> Rooski General Sun, 14 Apr 2013 15:50:25 -0400 https://reprap.org/forum/read.php?1,199585,199664#msg-199664 Re: ugh Heater issue again https://reprap.org/forum/read.php?1,199585,199664#msg-199664 Rooski General Sun, 14 Apr 2013 11:27:58 -0400 https://reprap.org/forum/read.php?1,199585,199618#msg-199618 Re: ugh Heater issue again https://reprap.org/forum/read.php?1,199585,199618#msg-199618 waitaki General Sun, 14 Apr 2013 06:22:56 -0400 https://reprap.org/forum/read.php?1,199585,199585#msg-199585 ugh Heater issue again https://reprap.org/forum/read.php?1,199585,199585#msg-199585
any ideas why ?]]> Rooski General Sun, 14 Apr 2013 02:16:38 -0400