I do not know how to manage my three fans. I am using dual extruders so D9 is occupied. Is there any ways? I was to connect them directly to the PSU, but it doesn't sound too safe. https://reprap.org/forum/read.php?1,320977,320977#msg-320977 Tue, 19 May 2026 05:45:33 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,320977,320982#msg-320982 https://reprap.org/forum/read.php?1,320977,320982#msg-320982 jpan General Thu, 06 Mar 2014 20:27:48 -0500 https://reprap.org/forum/read.php?1,320977,320981#msg-320981 https://reprap.org/forum/read.php?1,320977,320981#msg-320981 this or this to be firmware controllable. Or an even simpler solution here (this would work with RAMPS just as easily as with the Sanguinololu).]]> NewPerfection General Thu, 06 Mar 2014 20:20:05 -0500 https://reprap.org/forum/read.php?1,320977,320977#msg-320977 https://reprap.org/forum/read.php?1,320977,320977#msg-320977 jpan General Thu, 06 Mar 2014 20:06:53 -0500