I am trying to finish up my printer, but I have ran into a problem with the Repetier host software. I can connect to the arduino in the arduino interface. I can upload the firmware and even connect in the reptier host program. The problem is that the printer dose not respond to any commands that I send it. I have no idea if it is a software or hardware probelm. Any help would be much appreciated. https://reprap.org/forum/read.php?1,323786,323786#msg-323786 Thu, 12 Mar 2026 18:58:46 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,323786,324253#msg-324253 https://reprap.org/forum/read.php?1,323786,324253#msg-324253 vreihen General Thu, 13 Mar 2014 11:50:52 -0400 https://reprap.org/forum/read.php?1,323786,324224#msg-324224 https://reprap.org/forum/read.php?1,323786,324224#msg-324224 tjb1 General Thu, 13 Mar 2014 10:42:38 -0400 https://reprap.org/forum/read.php?1,323786,323886#msg-323886 https://reprap.org/forum/read.php?1,323786,323886#msg-323886 gunnd14 General Wed, 12 Mar 2014 16:46:16 -0400 https://reprap.org/forum/read.php?1,323786,323878#msg-323878 https://reprap.org/forum/read.php?1,323786,323878#msg-323878 cat.farmer General Wed, 12 Mar 2014 16:35:09 -0400 https://reprap.org/forum/read.php?1,323786,323786#msg-323786 https://reprap.org/forum/read.php?1,323786,323786#msg-323786 gunnd14 General Wed, 12 Mar 2014 14:13:01 -0400