Hello to all I explain my problem, I started a gen 7 (1.5) with Marlin as firmware and during my testing Repetier when I am sending a command to move an axis, the other motors starts at the same time on same direction .. I then left one Pololu with its motor, all connected to my "X" part command and when the test engine meets all control Repetier, I click to move X or Y or Z the engine responds ... Mistere firmware or motherboard faulty ..? Thank you for your help Marc https://reprap.org/forum/read.php?1,359831,359831#msg-359831 Tue, 15 Sep 2026 23:59:38 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,359831,360792#msg-360792 https://reprap.org/forum/read.php?1,359831,360792#msg-360792
Now X and Y is progressing well against by the Z motor is made ​​clack clack and go without ever turning back ..

Someone has an idea?]]> cram121 General Mon, 26 May 2014 18:39:32 -0400 https://reprap.org/forum/read.php?1,359831,360106#msg-360106 https://reprap.org/forum/read.php?1,359831,360106#msg-360106
For a Gen7 I always recommend to use Teacup first, because this is known to work well. Other firmwares are more feature-rich but also more complex and with less emphasis on physically sane motions.]]> Traumflug General Sun, 25 May 2014 07:35:30 -0400 https://reprap.org/forum/read.php?1,359831,359831#msg-359831 https://reprap.org/forum/read.php?1,359831,359831#msg-359831
I explain my problem, I started a gen 7 (1.5) with Marlin as firmware and during my testing Repetier when I am sending a command to move an axis, the other motors starts at the same time on same direction ..

I then left one Pololu with its motor, all connected to my "X" part command and when the test engine meets all control Repetier, I click to move X or Y or Z the engine responds ... Mistere firmware or motherboard faulty ..?

Thank you for your help


Marc]]> cram121 General Sat, 24 May 2014 11:36:53 -0400