How can i use e1 like e0 Hello i am new to the world of 3d. I have a reprap machine.I use mks base v 1.2 controller. After a print that has been four hours, e0 output does not working what i have to do can i use e1 output like e0 is it possible please help me? https://reprap.org/forum/read.php?1,496646,496646#msg-496646 Fri, 04 Sep 2026 12:35:23 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,496646,497040#msg-497040 Re: How can i use e1 like e0 https://reprap.org/forum/read.php?1,496646,497040#msg-497040 My slicer program is migbot and it look like Cura and i do not know waht i have to do.]]> mahmu7 General Wed, 15 Apr 2015 02:59:32 -0400 https://reprap.org/forum/read.php?1,496646,497033#msg-497033 Re: How can i use e1 like e0 https://reprap.org/forum/read.php?1,496646,497033#msg-497033 I saw nozzle screw was clogged when i check it and i think e0 driver damagged because this reason.I tried my extruder motor on x axis output and it worked.
i am using cura but i could not find use e1.


and i have another problem with 12v input on board. i connected wrong and it is broken .the screen has a display but i cant control motors with usb power. But i only connect 12 dc it doesnt work. i think i burned input diodes. i hope it.]]> mahmu7 General Wed, 15 Apr 2015 02:44:51 -0400 https://reprap.org/forum/read.php?1,496646,496839#msg-496839 Re: How can i use e1 like e0 https://reprap.org/forum/read.php?1,496646,496839#msg-496839
The easiest way to switch to e1 would be that the firmware is already configured for two extruders, in that case just tell the slicing software to use the second extruder only and connect your extruder to e1 and change thermistor and heater connections accordingly.
If the firmware is not set up for two extruders you will have to update it. Either to one that supports two extruders, or you could change the pin mapping to use e1 as a replacement for e0.]]> Srek General Tue, 14 Apr 2015 14:01:25 -0400 https://reprap.org/forum/read.php?1,496646,496830#msg-496830 Re: How can i use e1 like e0 https://reprap.org/forum/read.php?1,496646,496830#msg-496830 iamdarkyoshi General Tue, 14 Apr 2015 13:35:11 -0400 https://reprap.org/forum/read.php?1,496646,496646#msg-496646 How can i use e1 like e0 https://reprap.org/forum/read.php?1,496646,496646#msg-496646 I have a reprap machine.I use mks base v 1.2 controller.
After a print that has been four hours, e0 output does not working
what i have to do can i use e1 output like e0 is it possible please help me?]]> mahmu7 General Tue, 14 Apr 2015 05:30:30 -0400