So it seems like my Prusa i2 will no longer connect to my pc, I'm getting the COM 5 error. I cleared out all serial ports with the registry edit tip suggested on this forum while searching for an answer. That did not work. The only option I have is to use my brother's macbook or a linux dual boot pc done on an old laptop. Im not liking the macbook option because if the screen goes to sleep or your browsing the internet, it throws off error codes and pauses the print in process. I tried the option disconnect printer from pc, kill application, kill power for a few seconds, reconnect power, reconnect to pc, launch application. This does not work. Restarting computer does not work for this type of problem. https://reprap.org/forum/read.php?1,515950,515950#msg-515950 Thu, 15 Oct 2026 07:29:41 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,515950,526573#msg-526573 https://reprap.org/forum/read.php?1,515950,526573#msg-526573 chuttney1 General Fri, 26 Jun 2015 23:57:06 -0400 https://reprap.org/forum/read.php?1,515950,520974#msg-520974 https://reprap.org/forum/read.php?1,515950,520974#msg-520974 chuttney1 General Fri, 12 Jun 2015 20:31:02 -0400 https://reprap.org/forum/read.php?1,515950,516327#msg-516327 https://reprap.org/forum/read.php?1,515950,516327#msg-516327
And what control board are you using?

Regards]]> ayouden General Mon, 01 Jun 2015 13:49:45 -0400 https://reprap.org/forum/read.php?1,515950,515950#msg-515950 https://reprap.org/forum/read.php?1,515950,515950#msg-515950 chuttney1 General Sun, 31 May 2015 15:30:30 -0400