Hi everyone, I have finally got access to an Ultimaker original 3D printer. I would like to print myself the parts for building the Wilson TS. I would like to set the printer for a good speed/sturdiness. Actually, I have no idea which settings to choose for a good quality of print in terms of filling, layers and whatsoever in Cura. I was wondering if anyone could kindly provide advices about the settings to use for printing parts. The printer has a 0.4mm nozzle and uses 3mm PLA thermoplastic. Any suggestions? Cheers, G https://reprap.org/forum/read.php?1,518299,518299#msg-518299 Sun, 13 Sep 2026 09:58:28 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,518299,521999#msg-521999 https://reprap.org/forum/read.php?1,518299,521999#msg-521999 mjrice General Mon, 15 Jun 2015 19:59:40 -0400 https://reprap.org/forum/read.php?1,518299,518299#msg-518299 https://reprap.org/forum/read.php?1,518299,518299#msg-518299
I have finally got access to an Ultimaker original 3D printer. I would like to print myself the parts for building the Wilson TS. I would like to set the printer for a good speed/sturdiness. Actually, I have no idea which settings to choose for a good quality of print in terms of filling, layers and whatsoever in Cura.
I was wondering if anyone could kindly provide advices about the settings to use for printing parts.

The printer has a 0.4mm nozzle and uses 3mm PLA thermoplastic.

Any suggestions?

Cheers,

G]]> gcannone General Sat, 06 Jun 2015 07:29:30 -0400