resolve this problem y axis the z anx x axis home fine etc but everytime the y axis homes iit makes this noise as if i keeps going had it since had the machine endstop wired up and led shows when hit se you video link [youtu.be] https://reprap.org/forum/read.php?1,535073,535073#msg-535073 Tue, 12 May 2026 05:52:59 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,535073,535508#msg-535508 Re: resolve this problem y axis https://reprap.org/forum/read.php?1,535073,535508#msg-535508
Quote
Dust
GREYWOLF, you are 100% wrong!

X homes correctly, so cannot be miss wired.

Min endstops are at back and left of a standard I3 type machine. Where the Y moves the bed. This is complealy independant of where the motor is.

Yes you are correct, serves me rights for tyring to do to many things at the same time.

Move the y-endstop closer to the front and try again, the beds front left corner should stop under the nozzel, if its not the endstop is not being read or is slipping. (I get this with the X carriage.]]> GRAYWOLF General Wed, 22 Jul 2015 01:44:45 -0400 https://reprap.org/forum/read.php?1,535073,535432#msg-535432 Re: resolve this problem y axis https://reprap.org/forum/read.php?1,535073,535432#msg-535432
X homes correctly, so cannot be miss wired.

Min endstops are at back and left of a standard I3 type machine. Where the Y moves the bed. This is complealy independant of where the motor is.]]> Dust General Tue, 21 Jul 2015 19:31:25 -0400 https://reprap.org/forum/read.php?1,535073,535367#msg-535367 Re: resolve this problem y axis https://reprap.org/forum/read.php?1,535073,535367#msg-535367 The bed should home to the front away from the motor! on top of the motor
Failing that, the endstop is slipping.]]> GRAYWOLF General Tue, 21 Jul 2015 17:00:02 -0400 https://reprap.org/forum/read.php?1,535073,535207#msg-535207 Re: resolve this problem y axis https://reprap.org/forum/read.php?1,535073,535207#msg-535207 trist077 General Tue, 21 Jul 2015 10:54:17 -0400 https://reprap.org/forum/read.php?1,535073,535131#msg-535131 Re: resolve this problem y axis https://reprap.org/forum/read.php?1,535073,535131#msg-535131
Is the Y endstop plugged ito the Y-Min or Y-max endstop plug (should be Y-Min) (presuming you even have a min and max, no mention of main board.)]]> Dust General Tue, 21 Jul 2015 09:00:15 -0400 https://reprap.org/forum/read.php?1,535073,535073#msg-535073 resolve this problem y axis https://reprap.org/forum/read.php?1,535073,535073#msg-535073
se you video link
[youtu.be]]]> trist077 General Tue, 21 Jul 2015 07:31:59 -0400