My X motor and endstop are on the left of the printer. It homes in the right direction, but prints are mirrored on that axis. Any ideas on how to fix this? A software solution would be preferable (and not mirroring the part in the slicer every print :P). https://reprap.org/forum/read.php?1,544821,544821#msg-544821 Tue, 15 Sep 2026 22:56:34 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,544821,545602#msg-545602 https://reprap.org/forum/read.php?1,544821,545602#msg-545602
Is there a reason you want it to home to the right? Can you not just put your endstop onto the left of the X axis and revert to homing in that direction? The homing is a reference to find the origin, putting to the X origin to the right will always mirror your prints.]]> atunguyd General Fri, 14 Aug 2015 06:51:50 -0400 https://reprap.org/forum/read.php?1,544821,545194#msg-545194 https://reprap.org/forum/read.php?1,544821,545194#msg-545194 phyllis_ave General Thu, 13 Aug 2015 02:58:41 -0400 https://reprap.org/forum/read.php?1,544821,544851#msg-544851 https://reprap.org/forum/read.php?1,544821,544851#msg-544851
I fixed it in the marlin firmware. and then set my settings in repetier.]]> pushthatbolder General Wed, 12 Aug 2015 04:17:03 -0400 https://reprap.org/forum/read.php?1,544821,544850#msg-544850 https://reprap.org/forum/read.php?1,544821,544850#msg-544850 quillford General Wed, 12 Aug 2015 04:09:55 -0400 https://reprap.org/forum/read.php?1,544821,544849#msg-544849 https://reprap.org/forum/read.php?1,544821,544849#msg-544849 What software are you using and have you tried other software?]]> GRAYWOLF General Wed, 12 Aug 2015 04:02:53 -0400 https://reprap.org/forum/read.php?1,544821,544821#msg-544821 https://reprap.org/forum/read.php?1,544821,544821#msg-544821 quillford General Wed, 12 Aug 2015 01:55:27 -0400