I purchased a E3d lite6 and it seems to be rocking back and forth in my wades extruder mount. Currently the hotend is inside of the mount secured by traditional screws. I bored out a countersink for the collet to fit but the hotel still can move a couple of degrees. Has anyone experienced this and has a fix? https://reprap.org/forum/read.php?1,579482,579482#msg-579482 Sat, 18 Jul 2026 23:02:03 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,579482,580976#msg-580976 https://reprap.org/forum/read.php?1,579482,580976#msg-580976 gmckee General Fri, 06 Nov 2015 17:58:22 -0500 https://reprap.org/forum/read.php?1,579482,580932#msg-580932 https://reprap.org/forum/read.php?1,579482,580932#msg-580932 DjDemonD General Fri, 06 Nov 2015 16:07:02 -0500 https://reprap.org/forum/read.php?1,579482,580459#msg-580459 https://reprap.org/forum/read.php?1,579482,580459#msg-580459
I printed a new mount with a 5.9mm groovemount, and my wiggle problems are gone.]]> Ezrec General Thu, 05 Nov 2015 14:55:02 -0500 https://reprap.org/forum/read.php?1,579482,580208#msg-580208 https://reprap.org/forum/read.php?1,579482,580208#msg-580208 RonN General Thu, 05 Nov 2015 04:32:13 -0500 https://reprap.org/forum/read.php?1,579482,579482#msg-579482 https://reprap.org/forum/read.php?1,579482,579482#msg-579482 gmckee General Tue, 03 Nov 2015 16:10:52 -0500