My prusa doesn't connect with either of my computers anymore. I used to use repitier to connect but neither it or cura works on multiple computers now. I can print fine from SD so im wondering how I can get computer connection back. My z axis needs to be at like 160% so all my SD prints are too short! Has anyone run into this before? https://reprap.org/forum/read.php?1,613144,613144#msg-613144 Sat, 13 Jun 2026 14:03:42 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,613144,618442#msg-618442 https://reprap.org/forum/read.php?1,613144,618442#msg-618442
People are reporting "The Arduino IDE's serial monitor reports: "NON GENUINE DEVICE FOUND" printed over and over again! "

You need to roll the driver back to a pre nasty version..
or run linux
or plug your controller into a raspberry pi running octoprint (so windows can't see the FTDI chip)
or get a non clone FTDI chip (though after all FTDI's nastiness I advise using a ch340 or alternative usb to serial converter.)]]> Dust General Sat, 30 Jan 2016 21:27:59 -0500 https://reprap.org/forum/read.php?1,613144,618077#msg-618077 https://reprap.org/forum/read.php?1,613144,618077#msg-618077
[hackaday.com]]]> JamesK General Sat, 30 Jan 2016 08:56:02 -0500 https://reprap.org/forum/read.php?1,613144,617779#msg-617779 https://reprap.org/forum/read.php?1,613144,617779#msg-617779 llsouder General Fri, 29 Jan 2016 16:11:09 -0500 https://reprap.org/forum/read.php?1,613144,613471#msg-613471 https://reprap.org/forum/read.php?1,613144,613471#msg-613471 gmckee General Thu, 21 Jan 2016 13:18:44 -0500 https://reprap.org/forum/read.php?1,613144,613144#msg-613144 https://reprap.org/forum/read.php?1,613144,613144#msg-613144 V.Adultman General Thu, 21 Jan 2016 00:43:09 -0500