Unfortunately I have a bit of a mess on my hands after having a filament leak from my Lite6 that resulted in a heater block covered in PLA. Are there any know ways to dissolve PLA out of the threads. With my crappy knock off hotend would jam I would heat it with the propane torch and burn it out but would rather not do that with the E3d. I believe it is stainless steel so the heat wouldn't mess with the metal too much. https://reprap.org/forum/read.php?1,615512,615512#msg-615512 Wed, 22 Jul 2026 06:39:33 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,615512,615865#msg-615865 https://reprap.org/forum/read.php?1,615512,615865#msg-615865
[www.homedepot.com]]]> ElmoC General Tue, 26 Jan 2016 08:55:21 -0500 https://reprap.org/forum/read.php?1,615512,615855#msg-615855 https://reprap.org/forum/read.php?1,615512,615855#msg-615855 DjDemonD General Tue, 26 Jan 2016 08:40:51 -0500 https://reprap.org/forum/read.php?1,615512,615840#msg-615840 https://reprap.org/forum/read.php?1,615512,615840#msg-615840
Just remember, it is only to be used on PLA!]]> Lykle General Tue, 26 Jan 2016 08:26:25 -0500 https://reprap.org/forum/read.php?1,615512,615512#msg-615512 https://reprap.org/forum/read.php?1,615512,615512#msg-615512 gmckee General Mon, 25 Jan 2016 14:53:55 -0500