I have a reprap Huxley that came into my possession with just bare wiring leads. I'm replacing the melzi mainboard with a duet board that has plugs (like you'd slide a jumper onto (but it looks like 4 pins next to each other). The best comparison i can make is that the plug looks like the 4pin header on a motherboard for the speaker. How do i change the wiring over? [www.replikeo.com] is the board I'm going to be installing... https://reprap.org/forum/read.php?1,617064,617064#msg-617064 Tue, 21 Jul 2026 13:19:46 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,617064,619475#msg-619475 https://reprap.org/forum/read.php?1,617064,619475#msg-619475 Kurzaa General Mon, 01 Feb 2016 14:00:22 -0500 https://reprap.org/forum/read.php?1,617064,617719#msg-617719 https://reprap.org/forum/read.php?1,617064,617719#msg-617719
I got a complete wiring set for an i3 delivered for £7. It's probably better than crimping them yourself unless you are good at crimping. Plus you can cut off the wire the length you want it's often useful to extend some cables to the right length.

I've got a crimper and can crimp okay but my soldered and heatshrinked joints are rock solid.]]> DjDemonD General Fri, 29 Jan 2016 14:51:38 -0500 https://reprap.org/forum/read.php?1,617064,617682#msg-617682 https://reprap.org/forum/read.php?1,617064,617682#msg-617682 dc42 General Fri, 29 Jan 2016 13:31:38 -0500 https://reprap.org/forum/read.php?1,617064,617674#msg-617674 https://reprap.org/forum/read.php?1,617064,617674#msg-617674 Srek General Fri, 29 Jan 2016 13:20:31 -0500 https://reprap.org/forum/read.php?1,617064,617662#msg-617662 https://reprap.org/forum/read.php?1,617064,617662#msg-617662
I found this kit on Amazon that has 2-way, 3-way, and 4-way plugs in it along with pins. Would this work?

[www.amazon.com]

and this crimping tool says it's for 3-way and 4-way, would it work for 2-way as well?

[www.amazon.com]

If not could someone point me in the direction of a page that has what I'm looking for? A kit w]]> ebola0 General Fri, 29 Jan 2016 12:56:35 -0500 https://reprap.org/forum/read.php?1,617064,617240#msg-617240 https://reprap.org/forum/read.php?1,617064,617240#msg-617240
The hot end heater connector is 4-way, allowing you to double up the wires running to the hot end, for greater current-carrying capacity.

HTH David]]> dc42 General Thu, 28 Jan 2016 17:24:52 -0500 https://reprap.org/forum/read.php?1,617064,617064#msg-617064 https://reprap.org/forum/read.php?1,617064,617064#msg-617064
How do i change the wiring over?

[www.replikeo.com] is the board I'm going to be installing...]]> ebola0 General Thu, 28 Jan 2016 12:14:49 -0500