I'm trying to use a paste extruder on my delta printer, obviously I don't need the hot end neither the heated bed. I'm using repetier as the host for the models I'm trying to print; on the printer settings I uncheck the extruder & bed temperature request but the printer doesn't start, is there another setting that I need to change? https://reprap.org/forum/read.php?1,652121,652121#msg-652121 Mon, 20 Jul 2026 21:42:02 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,652121,653003#msg-653003 https://reprap.org/forum/read.php?1,652121,653003#msg-653003 Dirty Steve General Sat, 16 Apr 2016 12:27:30 -0400 https://reprap.org/forum/read.php?1,652121,652587#msg-652587 https://reprap.org/forum/read.php?1,652121,652587#msg-652587 M302 P1 will over ride the wait till temperature setting set by Gcode but some firmware have a built in safety function that doesn't allow extrusion unless the extruder is above a set temperature. I don't know if M302 P1 can over ride this. If not you would have to check if you need to reflash the firmware with a lower safety temperature.]]> MCcarman General Fri, 15 Apr 2016 07:15:22 -0400 https://reprap.org/forum/read.php?1,652121,652265#msg-652265 https://reprap.org/forum/read.php?1,652121,652265#msg-652265 You will need to send it the g-code M302 allow cold extrudes
[reprap.org]]]> orictosh General Thu, 14 Apr 2016 11:15:28 -0400 https://reprap.org/forum/read.php?1,652121,652121#msg-652121 https://reprap.org/forum/read.php?1,652121,652121#msg-652121 cearza General Thu, 14 Apr 2016 01:03:52 -0400