Hello guys, I have a bit of a challenge for you. I have purchased a diamond hot end, and I want to run it next to my original hotend so I can print colors with the diamond, and supports or ninjaflex with the original. I am running Repetier firmware. I saw that there is a procedure in the reprap wiki for mixing nozzles in Repetier Host, but it doesn't look like I can specify a separate nozzle just for supports. Is there a way to do this? I know I can set the offsets and everything, but the tricky part is telling it which extruders share a hot end and which don't. Thanks in advance! https://reprap.org/forum/read.php?1,655277,655277#msg-655277 Sat, 11 Apr 2026 07:21:11 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,655277,655662#msg-655662 https://reprap.org/forum/read.php?1,655277,655662#msg-655662 I have an MKS Base V 1.2 board, and I was planning on using a CNC expansion board to add 4 more stepper drivers per the reprap wiki page. I will use the auxiliary pins on the board to assign to each stepper.]]> galaxyman7 General Fri, 22 Apr 2016 16:51:36 -0400 https://reprap.org/forum/read.php?1,655277,655349#msg-655349 https://reprap.org/forum/read.php?1,655277,655349#msg-655349 IMBoring25 General Thu, 21 Apr 2016 22:16:01 -0400 https://reprap.org/forum/read.php?1,655277,655277#msg-655277 https://reprap.org/forum/read.php?1,655277,655277#msg-655277 I have a bit of a challenge for you. I have purchased a diamond hot end, and I want to run it next to my original hotend so I can print colors with the diamond, and supports or ninjaflex with the original. I am running Repetier firmware.
I saw that there is a procedure in the reprap wiki for mixing nozzles in Repetier Host, but it doesn't look like I can specify a separate nozzle just for supports. Is there a way to do this? I know I can set the offsets and everything, but the tricky part is telling it which extruders share a hot end and which don't.
Thanks in advance!]]> galaxyman7 General Thu, 21 Apr 2016 16:03:54 -0400