I've had my printer for over a year and the other day thermal runaway tripped on the heated bed. I took a look around and saw my connector had melted down (Picture). Is it possible to alter pins.h of Marlin to use a spare pin that to trigger a DC SSR with a heatsink (Link) connected to a typical PCB heater? Or would it be better to replace the whole ramps board? Thanks in Advance https://reprap.org/forum/read.php?1,686792,686792#msg-686792 Tue, 16 Jun 2026 08:43:04 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,686792,686803#msg-686803 https://reprap.org/forum/read.php?1,686792,686803#msg-686803
I've driven one of my heated beds with an AC-SSR and power from a 12V transformer (what gives rougly 16VAC) without problems ...]]> VDX General Thu, 14 Jul 2016 15:12:17 -0400 https://reprap.org/forum/read.php?1,686792,686792#msg-686792 https://reprap.org/forum/read.php?1,686792,686792#msg-686792 Picture).

Is it possible to alter pins.h of Marlin to use a spare pin that to trigger a DC SSR with a heatsink (Link) connected to a typical PCB heater? Or would it be better to replace the whole ramps board?

Thanks in Advance]]> gmckee General Thu, 14 Jul 2016 14:26:05 -0400