Something weird to ask... i started printing stuff not long ago , was printing out some calibration cube but i realized that the height of my prints are weird , it feels like its shorter then the actual models height , for example : i printed a 0.5mm thin wall that has a 1cm height but it came out only 0.66cm. Tested on an chess piece model also , the item printed out looks like its been squashed by something. Any idea about this problem? using Repetier and Slic3r for software. https://reprap.org/forum/read.php?1,704697,704697#msg-704697 Sat, 18 Jul 2026 19:41:25 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,704697,704847#msg-704847 https://reprap.org/forum/read.php?1,704697,704847#msg-704847 Dust General Sat, 03 Sep 2016 03:42:12 -0400 https://reprap.org/forum/read.php?1,704697,704846#msg-704846 https://reprap.org/forum/read.php?1,704697,704846#msg-704846 icyanima General Sat, 03 Sep 2016 03:37:16 -0400 https://reprap.org/forum/read.php?1,704697,704710#msg-704710 https://reprap.org/forum/read.php?1,704697,704710#msg-704710 stephenrc General Fri, 02 Sep 2016 09:51:13 -0400 https://reprap.org/forum/read.php?1,704697,704709#msg-704709 https://reprap.org/forum/read.php?1,704697,704709#msg-704709 PDBeal General Fri, 02 Sep 2016 09:49:46 -0400 https://reprap.org/forum/read.php?1,704697,704697#msg-704697 https://reprap.org/forum/read.php?1,704697,704697#msg-704697 icyanima General Fri, 02 Sep 2016 08:46:40 -0400