Hi there. After long proccess of building my repstrap, I started to print! My setup is: Repstrap + arduino mega + custom shield. software: skeinforge and for printing - repsnapper. Extruder: extruding ABS (3 mm diameter) through 0.5 mm nozzle. My setting in skeinforge (main ones..) - for speed - Feed rate of 30 mm and flow rate of 16 mm. I am trying to improve my print quality as much as I can. so - you are welcome to make suggestions :) Enjoy the pictures: Link Link https://reprap.org/forum/read.php?1,72223,72223#msg-72223 Fri, 14 Aug 2026 05:54:09 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,72223,72263#msg-72263 https://reprap.org/forum/read.php?1,72223,72263#msg-72263
looks like you have a fully equiped workshop there :)

If I am not mistaken you are taking a novel approach to the extruder problem in that you don't have a 'cold' zone which is typically provided by PEEK. Is that correct?

Do you get much ooze while running the print or is the ooze at the entrance just when starting/stopping?

cheers]]> AgeingHippy General Tue, 01 Feb 2011 04:56:34 -0500 https://reprap.org/forum/read.php?1,72223,72223#msg-72223 https://reprap.org/forum/read.php?1,72223,72223#msg-72223
After long proccess of building my repstrap, I started to print!

My setup is: Repstrap + arduino mega + custom shield.

software: skeinforge and for printing - repsnapper.

Extruder: extruding ABS (3 mm diameter) through 0.5 mm nozzle.

My setting in skeinforge (main ones..) - for speed - Feed rate of 30 mm and flow rate of 16 mm.

I am trying to improve my print quality as much as I can. so - you are welcome to make suggestions :)



Enjoy the pictures:

Link Link]]> eranglr General Mon, 31 Jan 2011 16:31:40 -0500