i have not changed anything for my deltabot, however the printing temperature recently become unstable, the extruder temperature is always jumping higher or lower than the targeted temp at a big range(around 20-30 degrees higher or 10-15 degrees lower), sometimes it triggered the max temp error. i have checked the hardware and ensure that everything is in the right place, and i have runned the PID tuning and input the value accordingly, unfortunately the problem still exists. anyone knows what's the cause? thank you https://reprap.org/forum/read.php?1,723776,723776#msg-723776 Tue, 13 Oct 2026 05:42:57 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,723776,724294#msg-724294 https://reprap.org/forum/read.php?1,723776,724294#msg-724294 DaGameFace General Sat, 19 Nov 2016 11:40:32 -0500 https://reprap.org/forum/read.php?1,723776,723782#msg-723782 https://reprap.org/forum/read.php?1,723776,723782#msg-723782
Once you find and fix the problem you'll need to run the PID tuning again and save the returned values in the config file.]]> the_digital_dentist General Thu, 17 Nov 2016 08:04:27 -0500 https://reprap.org/forum/read.php?1,723776,723776#msg-723776 https://reprap.org/forum/read.php?1,723776,723776#msg-723776
i have checked the hardware and ensure that everything is in the right place, and i have runned the PID tuning and input the value accordingly, unfortunately the problem still exists.

anyone knows what's the cause?

thank you]]> bluesduff General Thu, 17 Nov 2016 07:55:19 -0500