Hi all, would like to ask for Cura flow settings. I have right diameter around 1,73mm and stepper motor also calibrated and I have still bad over-extruded results with flow 100% in Cura. I use ABS. Is it normal to have flow rating set around 70% or lower, where is overextruding starting to be not visible ? https://reprap.org/forum/read.php?1,799107,799107#msg-799107 Mon, 16 Mar 2026 20:40:33 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,799107,799107#msg-799107 https://reprap.org/forum/read.php?1,799107,799107#msg-799107 would like to ask for Cura flow settings. I have right diameter around 1,73mm and stepper motor also calibrated and I have still bad over-extruded results with flow 100% in Cura. I use ABS.
Is it normal to have flow rating set around 70% or lower, where is overextruding starting to be not visible ?]]> Arnold General Sat, 02 Dec 2017 15:49:16 -0500