Hi all. Question: pud autoninng can give us a pretty close to good PID tuning, but good tunning requires some extra adjustment. Can PID tuning be done WHILE printing a test object? Thanks. https://reprap.org/forum/read.php?1,838129,838129#msg-838129 Thu, 16 Apr 2026 08:09:04 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,838129,838270#msg-838270 https://reprap.org/forum/read.php?1,838129,838270#msg-838270 manual PID tuning by tweaking the PID parameters you've found earlier, then yes.]]> o_lampe General Sun, 11 Nov 2018 23:23:36 -0500 https://reprap.org/forum/read.php?1,838129,838241#msg-838241 https://reprap.org/forum/read.php?1,838129,838241#msg-838241
Even better would be to have a range of PID settings that can be set based on extruded volume. I think I've seen this somewhere but I can't remember. I'm sure someone more knowledgeable will chime in.]]> imqqmi General Sun, 11 Nov 2018 12:38:42 -0500 https://reprap.org/forum/read.php?1,838129,838129#msg-838129 https://reprap.org/forum/read.php?1,838129,838129#msg-838129 Thanks.]]> kullboys General Fri, 09 Nov 2018 21:42:27 -0500