Hello everyone, I have an AIO II v3.2 running a createbot max 3D printer. The printer was working great with a 24V 50W hot end. The hot end suddenly stopped heating a few days ago, only the green led next to the mosfet flickers for a while and then switches off. I tried flashing the firmware on it and instead of testing it with the hot end again, I tried it with the hot bed and hot bed thermistor. It worked perfectly fine but the moment I switched it back to the hot end and hot end thermistor, it would switch off and stop heating. I would like to have your thoughts on this issue. Also will the microcontroller switch off the mosfet automatically if it senses a short in the hot end ? https://reprap.org/forum/read.php?1,887109,887109#msg-887109 Sat, 11 Apr 2026 08:40:02 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?1,887109,887137#msg-887137 https://reprap.org/forum/read.php?1,887109,887137#msg-887137 Shakthi General Tue, 23 Nov 2021 03:51:09 -0500 https://reprap.org/forum/read.php?1,887109,887113#msg-887113 https://reprap.org/forum/read.php?1,887109,887113#msg-887113 dc42 General Mon, 22 Nov 2021 09:32:03 -0500 https://reprap.org/forum/read.php?1,887109,887109#msg-887109 https://reprap.org/forum/read.php?1,887109,887109#msg-887109
I have an AIO II v3.2 running a createbot max 3D printer. The printer was working great with a 24V 50W hot end. The hot end suddenly stopped heating a few days ago, only the green led next to the mosfet flickers for a while and then switches off. I tried flashing the firmware on it and instead of testing it with the hot end again, I tried it with the hot bed and hot bed thermistor. It worked perfectly fine but the moment I switched it back to the hot end and hot end thermistor, it would switch off and stop heating.

I would like to have your thoughts on this issue. Also will the microcontroller switch off the mosfet automatically if it senses a short in the hot end ?]]> Shakthi General Mon, 22 Nov 2021 05:33:29 -0500