I have changed the names of a few things in the properties file to add their dimensions: Extruder0_NozzleWipeDatumX(mm) Extruder0_NozzleWipeDatumY(mm) Extruder0_NozzleWipeStroke(mm) Extruder0_ShortLength(mm) Extruder0_ShortSpeed(0..1) And added a new number to play with: Extruder0_InfillOverlap(mm) This defaults to 0, when it has no effect. But if you put a number in it, the infill hatch will overlap by that many mm with the outline; this allows you to stick them together tighter, but doing it too much will cause distortion, of course. Negative values will create a gap. (There are corresponding ones for Extruder1_xxxx, of course). https://reprap.org/forum/read.php?12,8657,8657#msg-8657 Wed, 15 Jul 2026 05:50:35 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?12,8657,8657#msg-8657 https://reprap.org/forum/read.php?12,8657,8657#msg-8657
Extruder0_NozzleWipeDatumX(mm)
Extruder0_NozzleWipeDatumY(mm)
Extruder0_NozzleWipeStroke(mm)
Extruder0_ShortLength(mm)
Extruder0_ShortSpeed(0..1)

And added a new number to play with:

Extruder0_InfillOverlap(mm)

This defaults to 0, when it has no effect. But if you put a number in it, the infill hatch will overlap by that many mm with the outline; this allows you to stick them together tighter, but doing it too much will cause distortion, of course. Negative values will create a gap.

(There are corresponding ones for Extruder1_xxxx, of course).]]> Adrian Bowyer RepRap Host Sat, 19 Jan 2008 12:24:38 -0500