Hi peeps been helping a friend has a reprap persua Mendel with a menzi board We've had it up and running but needed some minor adjusting doing to axis etc After turning off going bed etc returned to it in am now unable to connect to it We run through amount of checks from on here started from scratch with software But still not connecting just waits board been disconnected from everything bar power and PC Still nothing now ran out of ideas and technical knowledge please could someone help us Willing to travel a short distance to get tuff checked out Hope to hear back thanks for your time Photo of board attached to check we on about right one lol https://reprap.org/forum/read.php?13,164813,164813#msg-164813 Tue, 19 May 2026 05:23:09 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?13,164813,164813#msg-164813 https://reprap.org/forum/read.php?13,164813,164813#msg-164813 We've had it up and running but needed some minor adjusting doing to axis etc
After turning off going bed etc returned to it in am now unable to connect to it
We run through amount of checks from on here started from scratch with software
But still not connecting just waits board been disconnected from everything bar power and PC
Still nothing now ran out of ideas and technical knowledge please could someone help us
Willing to travel a short distance to get tuff checked out
Hope to hear back thanks for your time

Photo of board attached to check we on about right one lol]]> rhys1443 Controllers Wed, 07 Nov 2012 08:18:16 -0500