I'm looking forward to being able to complete a step without having to ask a question - wonder when(/if) that will be? The screw terminal on the noise suppressor board has 2 legs to solder, but also it contacts 2 other pads on the board - are these supposed to be soldered as well, or can I just solder the leads? Hazel. https://reprap.org/forum/read.php?13,27234,27234#msg-27234 Wed, 17 Jun 2026 03:28:21 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?13,27234,27255#msg-27255 https://reprap.org/forum/read.php?13,27234,27255#msg-27255 MotorAssist Controllers Mon, 07 Sep 2009 17:59:22 -0400 https://reprap.org/forum/read.php?13,27234,27252#msg-27252 https://reprap.org/forum/read.php?13,27234,27252#msg-27252
Lining it up to the edge might it works easier, but be sure not the break the tabs by bending too much :)]]> sam0737 Controllers Mon, 07 Sep 2009 15:54:36 -0400 https://reprap.org/forum/read.php?13,27234,27245#msg-27245 https://reprap.org/forum/read.php?13,27234,27245#msg-27245 Also, how on earth do you get the motor tabs soldered? Are they supposed to be right up against one edge of their holes?]]> MotorAssist Controllers Mon, 07 Sep 2009 12:42:52 -0400 https://reprap.org/forum/read.php?13,27234,27242#msg-27242 https://reprap.org/forum/read.php?13,27234,27242#msg-27242
It doesn't hurt if have them accidentally soldered, no worry.]]> sam0737 Controllers Mon, 07 Sep 2009 11:52:41 -0400 https://reprap.org/forum/read.php?13,27234,27234#msg-27234 https://reprap.org/forum/read.php?13,27234,27234#msg-27234
The screw terminal on the noise suppressor board has 2 legs to solder, but also it contacts 2 other pads on the board - are these supposed to be soldered as well, or can I just solder the leads?

Hazel.]]> MotorAssist Controllers Mon, 07 Sep 2009 10:11:21 -0400