I've decided to create my own version of the Reprap - I already have a functioning XYZ table and a Sanguino and I was wondering if there is a pinout for what signals are produced from the Reprap firmware? Are these standard DIR/STEP signals for each of the X/Y/Z axes? Essentially I'm going to try to graft the sanguino onto my motor controller board. Thanks, Steve https://reprap.org/forum/read.php?13,32637,32637#msg-32637 Thu, 12 Mar 2026 10:08:54 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?13,32637,32638#msg-32638 https://reprap.org/forum/read.php?13,32637,32638#msg-32638
[reprap.org]

Both arduino and Sanguino diagrams are about 1/2 way down the page. This is for the gen 2 electronics.

Bob]]> bobt Controllers Tue, 12 Jan 2010 15:01:37 -0500 https://reprap.org/forum/read.php?13,32637,32637#msg-32637 https://reprap.org/forum/read.php?13,32637,32637#msg-32637
- I already have a functioning XYZ table and a Sanguino and I was wondering if there is a pinout for what signals are produced from the Reprap firmware?

Are these standard DIR/STEP signals for each of the X/Y/Z axes?

Essentially I'm going to try to graft the sanguino onto my motor controller board.

Thanks,
Steve]]> shobley Controllers Tue, 12 Jan 2010 14:57:23 -0500