I've finally got Simplify3D running, I like it a lot. I'm wondering if it will work with the Duet+Duex hardware running RepRap firmware? My Duet is still sat in its box waiting for something to put it in, so thought I'd ask. I'm going to ask over in the Simplify forums too once I have access. https://reprap.org/forum/read.php?13,427977,427977#msg-427977 Tue, 16 Jun 2026 08:09:53 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?13,427977,428294#msg-428294 https://reprap.org/forum/read.php?13,427977,428294#msg-428294 dc42 Controllers Wed, 05 Nov 2014 04:50:19 -0500 https://reprap.org/forum/read.php?13,427977,428281#msg-428281 https://reprap.org/forum/read.php?13,427977,428281#msg-428281 UkIan Controllers Wed, 05 Nov 2014 04:19:48 -0500 https://reprap.org/forum/read.php?13,427977,428278#msg-428278 https://reprap.org/forum/read.php?13,427977,428278#msg-428278
Also, you get better prints if you print direct from SD card. The Duet USB interface is quite fast because there is no serial link involved, but even so, the data rate can't always keep up with the printer.]]> dc42 Controllers Wed, 05 Nov 2014 04:09:13 -0500 https://reprap.org/forum/read.php?13,427977,428132#msg-428132 https://reprap.org/forum/read.php?13,427977,428132#msg-428132 isonoob Controllers Tue, 04 Nov 2014 16:25:55 -0500 https://reprap.org/forum/read.php?13,427977,427977#msg-427977 https://reprap.org/forum/read.php?13,427977,427977#msg-427977 UkIan Controllers Tue, 04 Nov 2014 08:56:52 -0500