So, I was working on my extruder when i look at my hot end temp and it was reading 280c and climbing when it was set to 210c . So i shut off the power disconnect the heater and temp prob turn it back and now i can not connect via web and it is not pulling a IP. I can connect using USB i have flash it with the new DC42 firmware and updated the SD card and Pronterface kind of works . Still cant connect so i check the Atmel chip and its burn my finger hot form what i have read that is not a good sign:( . So is my board dead? and if so why? https://reprap.org/forum/read.php?13,601533,601533#msg-601533 Fri, 06 Mar 2026 06:59:39 -0500 Phorum 5.2.23 https://reprap.org/forum/read.php?13,601533,601757#msg-601757 https://reprap.org/forum/read.php?13,601533,601757#msg-601757 [attachment 68428 L7.jpg]]]> Trix Controllers Mon, 28 Dec 2015 12:54:40 -0500 https://reprap.org/forum/read.php?13,601533,601577#msg-601577 https://reprap.org/forum/read.php?13,601533,601577#msg-601577 dc42 Controllers Mon, 28 Dec 2015 03:58:52 -0500 https://reprap.org/forum/read.php?13,601533,601533#msg-601533 https://reprap.org/forum/read.php?13,601533,601533#msg-601533 Trix Controllers Mon, 28 Dec 2015 01:41:57 -0500