Shunt placement? I can't figure out how to correctly place the shunts (jumpers) on my SKR v1.4. I have a set of 4 DRV8825s and a set of TMC2208s that I can use. Where should I place the shunts for my Kossel to work? I don't know if I should go standalone or UART. Whatever it takes to get me printing again. TIA https://reprap.org/forum/read.php?13,869611,869611#msg-869611 Thu, 21 May 2026 01:02:52 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?13,869611,869629#msg-869629 Re: Shunt placement? https://reprap.org/forum/read.php?13,869611,869629#msg-869629
For the DRV8825s you must use step and direction mode.



For the TMC2208s you can run in step and direction mode as above. Or enable UART mode and allow the software to control the stepper drivers fully


]]> Dust Controllers Sun, 29 Mar 2020 23:17:40 -0400 https://reprap.org/forum/read.php?13,869611,869611#msg-869611 Shunt placement? https://reprap.org/forum/read.php?13,869611,869611#msg-869611 I can't figure out how to correctly place the shunts (jumpers) on my SKR v1.4. I have a set of 4 DRV8825s and a set of TMC2208s that I can use. Where should I place the shunts for my Kossel to work? I don't know if I should go standalone or UART. Whatever it takes to get me printing again. TIA]]> norwestie Controllers Sun, 29 Mar 2020 14:55:30 -0400