I have a folger tech i3 2020 that I recently setup auto level on. I have a micro switch and I have the unit probing in 4 fours and the offsets on the hot end are within .2mm prints are turning out very good from this. However even though I centered the object in cura the prints are not centered they are printing far right as if that is the center. I am not sure what is the cause of this. I have attached my config.h file. Any help on this would be great. I followed the 3 part series here [www.youtube.com] To get this far. https://reprap.org/forum/read.php?14,710611,710611#msg-710611 Wed, 07 Oct 2026 21:23:48 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?14,710611,710611#msg-710611 https://reprap.org/forum/read.php?14,710611,710611#msg-710611 www.youtube.com]
To get this far.]]> crumb4life Mechanics Thu, 29 Sep 2016 13:58:08 -0400