I have dual extruders and my second extruder skips steps whenever I print with it. I have tried increasing the current by turning the little screw on the driver counterclockwise, which makes it stop skipping, but then the printer shuts down mid-print, which probably means it was using too much voltage. Is there a better way to resolve this issue than increasing the current? Thanks in advance https://reprap.org/forum/read.php?14,767880,767880#msg-767880 Tue, 16 Jun 2026 08:06:25 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?14,767880,768022#msg-768022 https://reprap.org/forum/read.php?14,767880,768022#msg-768022 frankvdh Mechanics Sun, 14 May 2017 17:00:31 -0400 https://reprap.org/forum/read.php?14,767880,767923#msg-767923 https://reprap.org/forum/read.php?14,767880,767923#msg-767923 Srek Mechanics Sun, 14 May 2017 07:35:48 -0400 https://reprap.org/forum/read.php?14,767880,767880#msg-767880 https://reprap.org/forum/read.php?14,767880,767880#msg-767880 CounterSkil Mechanics Sun, 14 May 2017 02:46:08 -0400