I have a Folger Tech Prusa I3 with its original firmware on it. I have messed around with the "Marlin 1.0.2" firmware some, but I am having problems. I do understand that these printers can be setup in multiple ways. My hardware is all still "stock" Does anyone have a tweaked marlin firmware for the Folger Tech Prusa I3 that I can look at? I have burned 2 holes in my bed and a worn belt from my failed attempts at learning this. Thank you for helping me and passing knowledge along. https://reprap.org/forum/read.php?146,506260,506260#msg-506260 Tue, 19 May 2026 05:18:13 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?146,506260,506260#msg-506260 https://reprap.org/forum/read.php?146,506260,506260#msg-506260 not1ofthepack Firmware - mainstream and related support Thu, 07 May 2015 09:55:28 -0400