I would like to adjust my prusa i3's (hesine) Marlin. Most of the current settings are good and accurate so I would like to keep them and have them as a reference. I mainly just want to adjust the extruder. The manufacturer of my printer didn't include a copy of firmware settings with the kit minus what's on the control board. Is there a way to view the settings on the control board? https://reprap.org/forum/read.php?146,576617,576617#msg-576617 Sun, 15 Mar 2026 13:26:11 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?146,576617,577763#msg-577763 https://reprap.org/forum/read.php?146,576617,577763#msg-577763 Allnight Firmware - mainstream and related support Sat, 31 Oct 2015 04:19:33 -0400 https://reprap.org/forum/read.php?146,576617,576786#msg-576786 https://reprap.org/forum/read.php?146,576617,576786#msg-576786
There are MANY parameters, however, that are not visible anywhere other than in the source code.]]> jbernardis Firmware - mainstream and related support Wed, 28 Oct 2015 22:13:37 -0400 https://reprap.org/forum/read.php?146,576617,576617#msg-576617 https://reprap.org/forum/read.php?146,576617,576617#msg-576617 Allnight Firmware - mainstream and related support Wed, 28 Oct 2015 13:32:34 -0400