Hi I'm trying to upgrade my ender6 with my coreXY kinematic, the z-stop switch is not working for me. I've rung it with a multimeter - it's set to normally closed and rings when it's not closed, and doesn't ring when it's closed, as it should, so the switch circuit isn't the problem. I have already configured the firmware via [teamgloomy.github.io] , where I set the z-switch, and disabled the bl-touch. M119 gives the same result for the z axis - that I pressed the sensor, that I did not press it - that it does not work, while the x and y axes work normally. Well, apart from the fact that I have the z-axis reversed and the table moves up instead of going down, but now I at least need to adjust this switch. https://reprap.org/forum/read.php?146,889254,889254#msg-889254 Sun, 08 Mar 2026 23:38:01 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?146,889254,889372#msg-889372 https://reprap.org/forum/read.php?146,889254,889372#msg-889372 which drivers are you using?]]> jay_s Firmware - mainstream and related support Tue, 10 May 2022 06:39:57 -0400 https://reprap.org/forum/read.php?146,889254,889261#msg-889261 https://reprap.org/forum/read.php?146,889254,889261#msg-889261 FirstBarrel Firmware - mainstream and related support Mon, 02 May 2022 10:12:52 -0400 https://reprap.org/forum/read.php?146,889254,889257#msg-889257 https://reprap.org/forum/read.php?146,889254,889257#msg-889257 FirstBarrel Firmware - mainstream and related support Mon, 02 May 2022 03:12:18 -0400 https://reprap.org/forum/read.php?146,889254,889256#msg-889256 https://reprap.org/forum/read.php?146,889254,889256#msg-889256
Z_MIN is when the bed is all the way up, Ie when the distance from the hotend to the bed is minimum
Z_MAX is when the bed is all the way down. Ie When the distance from the hotend to the bed is maximum.

Same with Z moves
Z+ should move the bed down, to increase the distance between hotend and bed
Z- should move the bed up, to decreases the distance between hotend and bed]]> Dust Firmware - mainstream and related support Sun, 01 May 2022 21:44:50 -0400 https://reprap.org/forum/read.php?146,889254,889254#msg-889254 https://reprap.org/forum/read.php?146,889254,889254#msg-889254 teamgloomy.github.io] , where I set the z-switch, and disabled the bl-touch. M119 gives the same result for the z axis - that I pressed the sensor, that I did not press it - that it does not work, while the x and y axes work normally. Well, apart from the fact that I have the z-axis reversed and the table moves up instead of going down, but now I at least need to adjust this switch.]]> FirstBarrel Firmware - mainstream and related support Sun, 01 May 2022 19:05:28 -0400