Hello! I have a generic question I don't understand. I'm building a corexy machine with duet board and rrf. The machine motion in xy direction is around 400x400mm but the bed is only 300x300. My homing is in one of the corner at 0,0. How do I define the bed (work) area? My bed starts around 50,50 and ends around 350,350. I was, ok maybe it is in the slicer, not in the printer config but I don't see such option in cura either? https://reprap.org/forum/read.php?146,889979,889979#msg-889979 Sun, 10 May 2026 04:55:42 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?146,889979,889986#msg-889986 https://reprap.org/forum/read.php?146,889979,889986#msg-889986 docs.duet3d.com].]]> dc42 Firmware - mainstream and related support Thu, 21 Jul 2022 02:06:45 -0400 https://reprap.org/forum/read.php?146,889979,889979#msg-889979 https://reprap.org/forum/read.php?146,889979,889979#msg-889979 I have a generic question I don't understand. I'm building a corexy machine with duet board and rrf. The machine motion in xy direction is around 400x400mm but the bed is only 300x300. My homing is in one of the corner at 0,0. How do I define the bed (work) area? My bed starts around 50,50 and ends around 350,350. I was, ok maybe it is in the slicer, not in the printer config but I don't see such option in cura either?]]> daninet Firmware - mainstream and related support Wed, 20 Jul 2022 16:26:01 -0400