Hello, I just finished assembling my RepRapPro Mendel and started checking resistances at several points, following the assembly instructions. For the resistance between the screws of the power connector on the board, the instructions say this should level out to "infinity", which obviously depends on your perspective / multimeter settings. I'm reading 136.2 Ohms on my machine. Is this a plausible value for a correctly assembled machine, or should I go and find out what I did wrong? Thanks in advance for your replies. https://reprap.org/forum/read.php?151,166632,166632#msg-166632 Wed, 16 Sep 2026 20:03:16 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?151,166632,166767#msg-166767 https://reprap.org/forum/read.php?151,166632,166767#msg-166767 pjotrx General Mendel Topics Sun, 18 Nov 2012 08:20:41 -0500 https://reprap.org/forum/read.php?151,166632,166632#msg-166632 https://reprap.org/forum/read.php?151,166632,166632#msg-166632
I just finished assembling my RepRapPro Mendel and started checking resistances at several points, following the assembly instructions. For the resistance between the screws of the power connector on the board, the instructions say this should level out to "infinity", which obviously depends on your perspective / multimeter settings. I'm reading 136.2 Ohms on my machine. Is this a plausible value for a correctly assembled machine, or should I go and find out what I did wrong? Thanks in advance for your replies.]]> pjotrx General Mendel Topics Sat, 17 Nov 2012 08:08:22 -0500