Hi! I swapped the m8 threaded rods with 1/4-20 rods. The problem im having is that the 1/4 nuts are a bit smaller and they rotate a bit inside the x-end traps. If i wrap them with tape i can get a good fit. Is there any x-end design for a i2 that uses 1/4 nuts? thanks! https://reprap.org/forum/read.php?151,167315,167315#msg-167315 Sun, 09 Aug 2026 19:23:27 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?151,167315,167390#msg-167390 https://reprap.org/forum/read.php?151,167315,167390#msg-167390 nic0laz General Mendel Topics Wed, 21 Nov 2012 14:51:24 -0500 https://reprap.org/forum/read.php?151,167315,167360#msg-167360 https://reprap.org/forum/read.php?151,167315,167360#msg-167360 james glanville General Mendel Topics Wed, 21 Nov 2012 11:29:00 -0500 https://reprap.org/forum/read.php?151,167315,167315#msg-167315 https://reprap.org/forum/read.php?151,167315,167315#msg-167315
I swapped the m8 threaded rods with 1/4-20 rods. The problem im having is that the 1/4 nuts are a bit smaller and they rotate a bit inside the x-end traps.

If i wrap them with tape i can get a good fit.

Is there any x-end design for a i2 that uses 1/4 nuts?

thanks!]]> nic0laz General Mendel Topics Wed, 21 Nov 2012 07:51:43 -0500