Hey all, I have just upgraded firmware on my Air2 which runs Gen6 electronics and Repetier firmware/host. M119 shows all stops as "L" when unused, and Y trigger to "H" when it should. When homing or during manual moves however the printer continues driving past the stop... Thoughts? Thanks Ash https://reprap.org/forum/read.php?151,294442,294442#msg-294442 Fri, 06 Mar 2026 06:45:46 -0500 Phorum 5.2.23 https://reprap.org/forum/read.php?151,294442,298715#msg-298715 https://reprap.org/forum/read.php?151,294442,298715#msg-298715
When you jog each axis, make sure that it moves towards the end stop when jogging in the negative direction. If not, you need to reverse the axis direction in configuration.h. It sounds like you need to do this with the y axis. It should move to the back, towards your end stop, when jogging in the negative direction. You might need to do this to all axes if they are all behaving the same way.]]> brnrd General Mendel Topics Tue, 21 Jan 2014 12:30:40 -0500 https://reprap.org/forum/read.php?151,294442,294815#msg-294815 https://reprap.org/forum/read.php?151,294442,294815#msg-294815 lazzymonk General Mendel Topics Tue, 14 Jan 2014 17:44:39 -0500 https://reprap.org/forum/read.php?151,294442,294787#msg-294787 https://reprap.org/forum/read.php?151,294442,294787#msg-294787
I have my y stop at the rear of the printer, should this be min or max?
Gen6 does not actually have max connectors that I know of and it trigger properly as a "MIN stop"
When I manually move the bed in the minus direction it comes forward, is this correct?

So confusing...]]> ashhhhh General Mendel Topics Tue, 14 Jan 2014 17:02:32 -0500 https://reprap.org/forum/read.php?151,294442,294741#msg-294741 https://reprap.org/forum/read.php?151,294442,294741#msg-294741 lazzymonk General Mendel Topics Tue, 14 Jan 2014 15:48:48 -0500 https://reprap.org/forum/read.php?151,294442,294717#msg-294717 https://reprap.org/forum/read.php?151,294442,294717#msg-294717 ashhhhh General Mendel Topics Tue, 14 Jan 2014 15:08:48 -0500 https://reprap.org/forum/read.php?151,294442,294442#msg-294442 https://reprap.org/forum/read.php?151,294442,294442#msg-294442
I have just upgraded firmware on my Air2 which runs Gen6 electronics and Repetier firmware/host.
M119 shows all stops as "L" when unused, and Y trigger to "H" when it should.
When homing or during manual moves however the printer continues driving past the stop...

Thoughts?

Thanks
Ash]]> ashhhhh General Mendel Topics Tue, 14 Jan 2014 06:23:24 -0500