I've printed out some replacement X-Axis Motor and Idler end pieces but the smooth rods slide into them quite easily not to the extent that they wobble but they pull out an push in with very little force ... while they are quite tight in the the parts I'm replacing and to insert or remove them while I can just pull or push using a twisting motion makes it much easier - if this makes sense ? So the question is ... is this OK or should I at least redo the idler end ? https://reprap.org/forum/read.php?151,310822,310822#msg-310822 Mon, 12 Oct 2026 05:55:45 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?151,310822,311891#msg-311891 https://reprap.org/forum/read.php?151,310822,311891#msg-311891 brnrd General Mendel Topics Mon, 17 Feb 2014 01:47:06 -0500 https://reprap.org/forum/read.php?151,310822,310883#msg-310883 https://reprap.org/forum/read.php?151,310822,310883#msg-310883 BarneyG General Mendel Topics Fri, 14 Feb 2014 09:46:43 -0500 https://reprap.org/forum/read.php?151,310822,310873#msg-310873 https://reprap.org/forum/read.php?151,310822,310873#msg-310873 n9jcv General Mendel Topics Fri, 14 Feb 2014 09:24:33 -0500 https://reprap.org/forum/read.php?151,310822,310822#msg-310822 https://reprap.org/forum/read.php?151,310822,310822#msg-310822
So the question is ... is this OK or should I at least redo the idler end ?]]> BarneyG General Mendel Topics Fri, 14 Feb 2014 07:04:32 -0500