Hello everyone, So I'm using the bed temperature change functionality in Chamber, and it's working well except for one thing. I have Turn print Bed Heater Off at Shut Down, but at the end of the prints I noticed it wasn't cooling down. When I looked at the end of my files, I noticed this: M140 S0 M140 S60.0 I'm pretty sure this means its turning the bed off, but then immediately turning it back on to max temp (I'm printing with PLA so it starts at 60 and goes down to 45, and there were no lines between these two). Is there somewhere else I need to switch off the bed? https://reprap.org/forum/read.php?154,178809,178809#msg-178809 Sun, 09 Aug 2026 18:33:04 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?154,178809,178837#msg-178837 https://reprap.org/forum/read.php?154,178809,178837#msg-178837 jbernardis Skeinforge Thu, 24 Jan 2013 00:23:09 -0500 https://reprap.org/forum/read.php?154,178809,178831#msg-178831 https://reprap.org/forum/read.php?154,178809,178831#msg-178831
Thanks!]]> TopherMan Skeinforge Wed, 23 Jan 2013 23:23:10 -0500 https://reprap.org/forum/read.php?154,178809,178829#msg-178829 https://reprap.org/forum/read.php?154,178809,178829#msg-178829 jbernardis Skeinforge Wed, 23 Jan 2013 22:56:11 -0500 https://reprap.org/forum/read.php?154,178809,178809#msg-178809 https://reprap.org/forum/read.php?154,178809,178809#msg-178809
So I'm using the bed temperature change functionality in Chamber, and it's working well except for one thing. I have Turn print Bed Heater Off at Shut Down, but at the end of the prints I noticed it wasn't cooling down. When I looked at the end of my files, I noticed this:

M140 S0
M140 S60.0

I'm pretty sure this means its turning the bed off, but then immediately turning it back on to max temp (I'm printing with PLA so it starts at 60 and goes down to 45, and there were no lines between these two). Is there somewhere else I need to switch off the bed?]]> TopherMan Skeinforge Wed, 23 Jan 2013 19:23:15 -0500