Hello there, Please see the attached drawing. I have created and the gcode using replicator37 as my machine supports that only. I have use 10% infill with 1 shell and no support. The wall thickness of my component is 1.5mm but it comes out to be 2.4mm. What mistake could I be doing or is it some other problem? Please guide me on this. An early reply will be highly appreciated. Thanks a lot in Advance. Tushar Patil. https://reprap.org/forum/read.php?154,344900,344900#msg-344900 Wed, 07 Oct 2026 21:42:35 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?154,344900,344900#msg-344900 https://reprap.org/forum/read.php?154,344900,344900#msg-344900
Please see the attached drawing. I have created and the gcode using replicator37 as my machine supports that only. I have use 10% infill with 1 shell and no support. The wall thickness of my component is 1.5mm but it comes out to be 2.4mm. What mistake could I be doing or is it some other problem? Please guide me on this. An early reply will be highly appreciated.

Thanks a lot in Advance.

Tushar Patil.]]> Artizen2000 Skeinforge Fri, 25 Apr 2014 02:11:03 -0400